GYS GYSPOT ARCPULL 350 Handbuch Seite 28

Repositioning of a dowel pin holder
• Position and screw thedowel pin holder into the barrel of
the gun.
Put the protection nozzle on the dowel pin support and tigh-
ten slightly.
• Put the dowel pin holder previously set int protection
nozzle.
• Screw on the protective nozzle.
• Reposition and screw the pad and the cover onto the earth
rod.
Note: When screwing on the various components, the gun
barrel must always be tightened/locked with a spanner.
Adjusting a dowel pin holder (ref. 064591)
• Unscrew the bolt and nut of the dowel pin holder.
• Insert the dowel pin in the nut holder.
• Aim at the screw of the dowel pin holder to obtain 5mm between its extremity and the thread of the insert ( threaded
stud, stud with internal thread)
• Block the nut.
Note: It is possible to weld inserts up to 45mm long. Above 30mm long, it
may be necessary to unscrew completely and reverse the direction of the
dowel pin holder adjustment screw.
Installation of the earth rods pad and the protective gas cover:
• Insert the protective gas cover into the earth rod pad and lock it with
the screw.
It is imperative that the cover is placed on the other side of the pad pushbuttons.
The gas protection cover must not be mounted on the ground pad when welding without gas pro-
tection.
28
GYSPOT ARCPULL 350
locknut
screws
Dowel pin holder
Protective
nozzle
Dowel pin holder support
Pad and cover
5 mm
Protective gas cover
Push buttons
EN
Barrel
Earth rod pad