Packaging; Starting Operation - Tecsis P3290 Betriebsanleitung

6. Packaging / 7. Starting, operation

6. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure sensors.

With flush version (P3291) including pre-assembled sealings and protection cap.

Inspect the pressure sensor for possible damage during transportation. Should there

be any obvious damage, inform the transport company and tecsis without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing

installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be

damaged.
In order to protect the diaphragm, the pressure connection of the instrument P3291 is provided
with a special protection cap.
Remove this protection cap by hand only just before installing the pressure sensor in

order to prevent any damage to the diaphragm or the thread.
Keep the protection cap of the pressure connection thread and the diaphragm for later

storage or transport.
Mount the protection cap when removing and transporting the instrument.

7. Starting, operation
Required tools: wrench (flats 27), screw driver
Diaphragm test for your safety
It is necessary that before starting the pressure sensor you test the diaphragm visually, as this
is a safety-relevant component.

!


Warning

26 Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
Downloaded from www.Manualslib.com
Pay attention to any liquid leaking out, for this points to a diaphragm damage.
Check the diaphragm visually for any damage (P3291).
Use the pressure sensor only if the diaphragm is undamaged.
Use the pressure sensor only if it is in a faultless condition as far as the
safety-relevant features are concerned.
manuals search engine
GB