Packaging; Starting, Operation - Tecsis PEX17 Betriebsanleitung

5. For your safety / 6. Packaging / 7. Starting, operation
Warning

6. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure sensors; with flush version PEX18 including pre-
„
assembled sealings and protection cap.
Inspect the pressure sensor for possible damage during transportation. Should there
„
be any obvious damage, inform the transport company and tecsis without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing
„
installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be
„
damaged.
In order to protect the diaphragm, the pressure connection of the instrument PEX18 is provided
with a special protection cap.
Remove this protection cap only just before installing the pressure sensor in order to
„
prevent any damage to the diaphragm or the thread.
Keep the protection cap of the pressure connection thread and the diaphragm for later
„
storage or transport.
Mount the protection cap when removing and transporting the instrument.
„

7. Starting, operation

Required tools: wrench (flats 27), screw driver
Betriebsanleitung/Operating instructions
Downloaded from www.Manualslib.com
Consider the details given in the EC-type examination certificate as well
as the respective country specific regulations for installation and operation
in hazardous areas (e.g.: IEC 60079-14). If you do not observe these stipula-
tions, serious injuries and/or damage can occur.
manuals search engine
GB
21