Initial Start-Up; Quick Start - Siemens SITRANS L 260 Schnellstartanleitung

Initial Startup
To prepare the SITRANS LR260 for operation, complete the following steps:
1.
a)
b)
c)
d)
e)
2.
a)
b)
c)
d)
3.
Quick Start Wizard via the handheld programmer
Notes:
• The Quick Start Wizard settings are inter-related and changes apply only after you click on
Yes in Apply? at the end of the Quick Start steps.
• Do not use the Quick Start wizard to modify individual parameters: see full parameter
listing in Operating Instructions (perform customization for your application only after the
Quick Start has been completed).

1. Quick Start

a)
b)
c)
d)
e)
f)
A5E32114443
Downloaded from www.Manualslib.com
Set the desired language:
Point the programmer at the display [from a maximum distance of 500 mm (1.6 ft)], then
press Right ARROW to activate PROGRAM mode and open menu level 1.
Press Up ARROW to scroll to Language (7.0) and Right ARROW
parameter view.
Press Right ARROW to enable Edit mode.
Scroll to the desired language and press Right ARROW
Press Mode to return to Measurement mode.
Set the device address (default = 126):
In PROGRAM mode, navigate to: Level Meter > Communication > Device Address (5.1).
Press RIGHT arrow , RIGHT arrow
mode.
If required, key in a new value and press RIGHT arrow
the new value.
Press Mode to return to Measurement mode.
Run the Quick Start Wizard via the handheld programmer (see below).
Point the programmer at the display, then press Right ARROW
mode and open menu level 1.
Press Right ARROW
Press Right ARROW to open Edit mode or Down ARROW
values and move directly to the next item.
To change a setting, scroll to the desired item or key in a new value.
After modifying a value, press Right ARROW
to move to the next item.
Quick Start settings take effect only after you select Yes to Apply changes in step 1.7.
SITRANS LR260 (PROFIBUS PA) – QUICK START MANUAL
manuals search engine
, to open parameter view and enable Edit
twice to navigate to menu item 1.1 and open parameter view.
to accept it and press Down ARROW
to open
to accept it.
to accept it. The LCD displays
to activate PROGRAM
to accept default
Page EN-15