Safety Instructions; Scope Of Delivery; Main Features; Technical Data - Camille Bauer KINAX HW730 Betriebsanleitung

Operating Instructions KINAX HW730-Modbus/TCP avec PoE
Programmable hollow-shaft transmitter for angular position

1. Safety instructions

1.1 Symbols
The symbols in these instructions point out risks and have
the following meaning:
Warning in case of risks.
Non-observance can result in malfunc-
tioning.
Non-observance can result in malfunctio-
ning and personal injury.
Information on proper product handling.
1.2 Intended use
• The angular position transmitter KINAX HW730-Modbus/
TCP with PoE is a precision instrument and serves the
acquisition and provision of digital measured values. Use
the transmitter for this purpose only.
• The angular position transmitter is not intended to measure
rotation speed.
• The device is intended for installation in industrial plants
and meets the requirements of EN 61010-1.
• Instrument versions with Germanischer Lloyd are only
provided for approved environmental categories.
• Manufacturer is not liable for any damage caused by in-
appropriate handling, modification or any application not
according to the intended purpose.
1.3 Commissioning
Installation, assembly, setup and commis-
•
sioning of the device has to be carried out
exclusively by skilled workers.
Observe manufacturer's operating inst-
•
ructions.
Check all electric connections prior to
•
commissioning the plant.
If assembly, electric connection or other
•
work on the device and the plant are not
carried out properly, this may result in mal-
functioning or breakdown of the device.
Safety measures should be taken to avoid
•
any danger to persons, any damage of the
plant and any damage of the equipment
due to breakdown or malfunctioning of
the device.
Do not operate the device outside of the
•
limit values stated in the operating inst-
ructions.
1.4 Repair work and modifications
Les réparations et les modifications doivent
uniquement être effectuées par le fabricant.
En cas d'intervention inappropriée sur
l'appareil, la garantie n'est pas valable.
Nous nous réservons le droit d'apporter
des modifications au produit afin de le
perfectionner.
16
1.5 Disposal
1.6 Transport and storage

2. Scope of delivery

1 KINAX HW730-Modbus/TCP with PoE programmable
hollow-shaft transmitter for angular position
1 HW730 torque support set 169 749
1 Safety instructions 172 734 (german, english, french)
1 Software and documentation CD 156 027
3. Application
KINAX HW730-Modbus/TCP with PoE is a robust absolute
hollow shaft angular position transmitter which, due to its
high mechanical load capacity, is particularly suited to ap-
plications in rough environments. It acquires the angular
position of a shaft in a non-contact manner and makes it
available via Modbus/TCP.

4. Main features

• Robust hollow-shaft transmitter for angular position
• Interface Modbus / TCP with Power over Ethernet (PoE)
• Continuous hollow shaft up to ∅ 30mm
• Highest degree of mechanical and electrical safety
• Waterproof and dustproof IP67/IP69K
• maintenance and wear-free
• Easy installation and fast commissioning
• Measuring range (zero point) and direction of rotation
can be parameterised via Modbus/TCP
• Free on-site parameterising via Software CB Manager
• With maritime execution (formely GL, Germanischer
Lloyd) available

5. Technical data

5.1 General
Measured quantity:
Measuring principle:
Operating Instructions HW730 Be
The disposal of devices and components
may only be realised in accordance with
good professional practice observing the
country-specific regulations.
Transport and store the devices exclusively
in their original packaging. Do not drop de-
vices or expose them to substantial shocks.
Angle of rotation
Capacitive method
Camille Bauer Metrawatt