Atos Medical Freevent XtraCare Bedienungsanleitung Seite 16

2. Instructions for use
The device is for single use and must be replaced at least every 24 hours, or
more often as needed (e.g. if clogged by mucus or wet).
To use Freevent XtraCare, gently attach the device to the tube using a clockwise
twisting motion (Fig. 1). To remove the device from the tracheostomy tube,
gently pull the device using a clockwise twisting motion.
2.1 Disposal
Always follow medical practice and national requirements regarding biohazard
when disposing of a used medical device.
3. Accessories
Freevent O Adaptor:
2
Freevent O Adaptor is an accessory for patients requiring supplemental
2
oxygen. The adaptor connects oxygen tubing of 1/8 inch (3.2 mm) diameter
to the oxygen port. CAUTION: The adaptor is for single use and should be
replaced when it becomes dirty, contaminated or shows any signs of damage.
Attach and detach the O Adaptor to the device as shown in Fig. 2 and Fig. 4.
2
Attach the oxygen tubing to the adaptor as shown in Fig. 3. Make sure the oxygen
tube goes beyond the conical edge of the connector (Fig. 3).
For ordering information, see end of this Instructions for Use. For additional
help or information, please see back cover of the Instructions for Use for
contact information.
4. Reporting
Please note that any serious incident that has occurred in relation to the device
shall be reported to the manufacturer and the national authority of the country
in which the user and/or patient resides.
16