Hold-Up Alarm - Honeywell IDENT-KEY 3 Bedienungsanleitung

24
8.3

Hold-up alarm

A hold-up alarm can be triggered via the operating unit keypad with a hold-up code.
The hold-up code is identical with the PIN with the exception of the last digit.
last digit. (For other digits, see Chapter 9 "Appendix").
Example : PIN
Hold-up code
The hold-up code is thus
A possible tens digit is
A hold-up alarm is triggered irrespective of whether the system is in an armed or disarmed state.
Even if the operating unit is used for AC functions, a hold-up alarm can be triggered.
Trigger hold-up alarm
Trigger hold-up alarm
with disarming
Trigger hold-up alarm
with AC door lock release
Note: The sequence
Acknowledgement:
Optical
Acoustical
(signal)
Action
Note: If a hold-up alarm is triggered, the "Alarm" indicator does not light up!
456789
45678
456784
not carried over.
0....9
IK-D
0....9
IK-D
0....9
(PIN + IK-D or IK-D + PIN) is
Authorization
Ready
(green)
Disarmed
Armed
(yellow)
Only when disarming
2 sec.
Positive acknowledg.
Hold-up alarm
Operating Manual IK3 Operating Unit with Keypad
9+5 4 =
Enter the hold-up code, acknowledgement follows
Activate the "disarm" key
Hold the IK data carrier in the reading range
(only if required for disarming)
Enter the hold-up code, acknowledgement follows
The system is disarmed
Hold the IK data carrier in the reading range
(only if required for AC function)
Enter the hold-up code, acknowledgement follows
Door lock release follows
irrelevant .
5 sec.
Dis-
armed
is triggered
A 5 is added to the
No authorization
Negative acknowledg.
Hold-up alarm is
not triggered