Possible Functions; Authorization Process - Honeywell IDENT-KEY 3 Bedienungsanleitung

Operating Manual IK3 Operating Unit with Keypad
6.

Possible functions

- Arm/disarm an intrusion detection system
- Trigger hold-up alarm
- Access control functions
- Control and switching functions
- Up to 100 control and switching functions (in conjunction with EU BUS-2).
- - Up to 16 control and switching functions (in conjunction with EU conventional).
- Info functions
The state of the system can be queried (e.g. arm / disarm / alarm).
- Learn mode
New data carriers can be learned and old ones deleted in learn mode.
- Define or alter PIN
1)
The maximum possible number depends on the central control unit in conjunction with EU BUS-2,
max. 512 in conjunction with EU conventional.
All functions are defined via programming of the central control unit/evaluation unit.
7.

Authorization process

There are different possibilities of calling functions. Which of these possibilities is used, is defined
in the programming of the central control unit/
Any IK2 / IK3 data carrier that is approved by the system (authorized) is referred to as an IK data
carrier (IK-D).
The following table provides an overview.
Function
Arm/disarm
Hold-up alarm
AC-Functions
Control functions
Info
Learn mode
(X) only required together with disarming or AC function
Quick
Only PIN
Only IK-D
PIN or IK-D
PIN + IK-D
(PIN = ersonal dentification umber) P
Quick only PIN
X
X
With the quick function, only the corresponding function key requires activating
(arm / disarm / function "F"). A PIN or IK data carrier is not required.
The function can be triggered after entering the PIN.
The function can be triggered after reading a valid IK data carrier.
PIN or IK data carrier are required to trigger the function.
PIN and IK data carrier are required to trigger the function.
The sequence
I N
EU .
only IK-D
X X
X
X X
X X
X X
X
(PIN + IK-D or IK-D + PIN) is
1)
1)
PIN or IK-D PIN + IK-D
X
X
X
X
irrelevant .
21
X
(X)
X
X
X