Control Functions - Honeywell IDENT-KEY 3 Bedienungsanleitung

26
8.6

Control functions

The control and switching functions can be executed via the operating unit keypad. The desired func-
tions are defined via the programming of the central control unit / evalutiation unit and activated via
the function number entered at the operating unit.
How to call the control functions is defined in the programming of the central control unit/EU.
Positive acknowledgement after action is completed ("Ready" indicator, signal)
If there is no authorization
edgement follows!
Call functions:
1. Activate key (Quick)
2. Only IK data carrier
3. Only PIN
4. With IK data carrier and PIN
or
With PIN and IK data carrier
or the entered function number does not exist
F
Activate the "F" function key
3
Confirm with "OK", acknowledgement follows
ATTENTION: Only 1 macro
F Activate the "F" key
Enter the function number
0....9
3
Confirm with "OK"
IK-D Hold the IK data carrier in the reading range,
acknowledgement follows
F
Activate the "F" key
0....9
Enter the function number
3
Confirm with "OK"
0....9
Enter PIN, acknowledgement follows
F Activate the "F" key
Enter the function number
0....9
3
Confirm with "OK"
Hold the IK data carrier in the reading range,
IK-D
"Ready" flashes 1x
0....9
Enter PIN, acknowledgement follows
F
Activate the "F" key
Enter the function number
0....9
3
Confirm with "OK"
Enter PIN, "Ready" flashes 1x
0....9
IK-D
Hold the IK data carrier in the reading range,
acknowledgement follows
Operating Manual IK3 Operating Unit with Keypad
, a negative acknowl-
is possible