Learn Mode - Honeywell IDENT-KEY 3 Bedienungsanleitung

Operating Manual IK3 Operating Unit with Keypad
8.7

Learn mode

Learn mode is used for the simple authorization of new data carriers or deleting already existing
ones.
In order to start and exit the learn mode, a
master key" is a data carrier that is defined exclusively in the system for this purpose.
As long as the learn mode is activated, any number of actions can be performed successively.
The "Alarm" indicator is used in the learn mode as an optical acknowledgement signal. It lights up
green, as long as the learn mode is activated. It flashes briefly to acknowledge an action that has
been performed.(s.b.).
The learn mode can only be activated in a
If an action cannot be performed, negative acknowledgement follows!
Note : The "Index" corresponds to the location in the memory (key number).
Start learn mode
Learn data carrier without index
Delete data carrier without index
Learn data carrier by index
Delete data carrier by index
Quit learn mode
"Learn master key"
disarmed state.
Hold the IK learn master key in the reading range
IK-L
3
Activate "OK"
The "Alarm" indicator lights up green
The actions can now be performed.
Hold new IK data carrier in the reading range
IK-D
3
Activate "OK"
"Alarm" indicator flashes 1x
Hold old IK data carrier in the reading range
IK-D
r
Activate "Delete"
"Alarm" indicator flashes 1x red
0....9
Enter new index
3
Activate "OK"
IK-D
Hold new IK data carrier in the reading range
3
Activate "OK"
"Alarm" indicator flashes 1x
Enter index
0....9
r
Activate the "Delete" key
Enter index again
0....9
r
Activate the "Delete" key
"Alarm" indicator flashes 1x red
Activate "Delete" key
r
"Alarm" indicator goes off
is required. This so-called "learn
Green
Green Red
Green
Green Red
27
Green
Green