Appendix - Honeywell IDENT-KEY 3 Bedienungsanleitung

30
9.

Appendix

New functions EU BUS-2 software V03.02 upwards and EU conv. software V01.xx upwards:
- Hold-up digit unequal 5
Contrary to the already defined hold-up digit "5", any digit other than "0" can be defined when
programming the central control unit. If several PINs exist, the defined digit applies to all PINs.
The addition to the PIN always remains identical, i.e. a possible carryover is ignored.
- Multiple use of PIN
Whether a PIN can be allocated once only or several times is determined when programming the
central control uni / EU.
If these functions are required, the following conditions must be fulfilled:
- EU BUS-2:
- In case of several EUs in a system,
- The software version of the central control unit must be V05.xx and upwards.
- Programming via WINFEM 100.10 from V05.xx upwards or WINFEM Advanced
upwards .
- EU conventional:
- Programming via WINFEM Advanced from V02.xx upwards.
Operating Manual IK3 Operating Unit with Keypad
all of the EUs must be updated at least to V03.02.
from V02.xx