Electrical Connection - IKEA UDDEN CG3 Bedienungsanleitung

ENGLISH
• Built-in ovens and built-in cooking surfaces
are fitted with special connection systems.
For safety reasons, you must only combine
appliances from the same manufacturer.

Electrical connection

Warning! Only a qualified electrician
and competent person must do the
electrical installation.
• The manufacturer is not responsible if you
do not follow these safety precautions.
• Ground the appliance according to safety
precautions.
• Make sure that the rated voltage and type
of power on the rating plate agree with the
voltage and the power of the local power
supply.
• This appliance is supplied without a plug
and a connection cable.
The following cable types are suitable for
use as mains cables, taking into account the
respective rated cross-section required:
H07RN-F, H05RN-F, H05RR-F, H05VVF,
H05V2V2-F (T90), H05BB-F.
• The yellow-green earth wire should be 2-3
cm longer than all other cables.
• The cable which is used to connect the oven
to the electrical supply must have a minimum
size of 4,0mm².
If the range is placed on a base, measures
have to be taken to prevent the appliance
slipping from the base.
• Any electrical component must be installed
or replaced by the After Sales Service tech-
nician or qualified service personnel.
• Always use a correctly installed shockproof
socket.
• Do not use multi-way plugs, connectors and
extension cables. There is a risk of fire.
• Make sure that the mains plug is accessible
after installation.
• Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
• Connect the appliance to the mains using a
device that allows to disconnect the appli-
ance from the mains at all poles with a con-
tact opening width of at least 3 mm, eg. au-
tomatic line protecting cut-out, earth leak-
age trips or fuse.
This appliance complies with the E.E.C. Direc-
tives.
8