Light (Led); Tips For Saving Energy - Bosch KGF Serie Gebrauchsanleitung

8. Put the frozen food back in the freezer
compartment.
Notes
Regularly clean the condensation
■
channel and drainage hole, Fig. +,
with a cotton bud or similar implement
to ensure that the condensation can
drain.
After cleaning, the stopper must be re-
■
inserted into the drainage hole of
the refrigerator compartment for
functional reasons.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. 5
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Removing the container
Fig. ,
Pull out the container all the way and lift
to detach it.
To insert the container, place on
the telescopic rails and push into
the appliance. Attach the container by
pressing it down.
Taking out the humidity filter
Fig. 1/16
The humidity filter over the humidity
container can be taken out for cleaning.
To do this, first take out the humidity
container and pull out the humidity filter.
Lift off the filter cover, Fig. -, and take
out the filter. Clean in lukewarm water,
leave to dry and re-assemble.
Taking out the frozen food container
Fig. 4
Pull out the frozen food container all
the way, lift at the front and remove.
General information for looking
after the surfaces
Clean surfaces with luke warm water
and a little washing-up liquid. After
cleaning, rub thoroughly dry.

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.

Tips for saving energy

Install the appliance in a dry, well
■
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
■
down before placing in the appliance!
When thawing frozen products, place
■
them in the refrigerator. Use
the coldness of the frozen food
to cool food.
Open the appliance as briefly
■
as possible.
Occasionally clean the rear
■
of the appliance to prevent an
increased power consumption.
If available: Fit wall spacers to obtain
■
the indicated energy rating of the
appliance (see Installation
instructions). A reduced wall gap will
not restrict the function of the
appliance. The energy rating may then
change slightly. The gap of 75 mm
must not be exceeded.
en
37