Technical Data; Safety Instructions; Symbols - Parkside PGSA 12 A1 Originalbetriebsanleitung

IE NI

Technical data

Cordless Grass & Hedge
Trimmer ...................... PGSA 12 A1
Motor voltage U .......................... 12 V
Rated speed n ...................... 1200 min
0
Protection category...........................IPX1
Sound power level (L
guaranteed ........................... 85 dB(A)
Weight (incl. accessories) .... approx 1.7 kg
Vibration (a
)
h
at handle ........ 2.02 m/s
Grass-trimming blade
Cutting width ..........................120 mm
Sound pressure level
(L ) ................75.6 dB(A), K
pA
Sound power level (L
measured ..81.0 dB(A); K
Shrub-trimming blade
Cutting length ........................170 mm
Cutting thickness .............. max. 7.9 mm
Sound pressure level
(L ) ................71.9 dB(A), K
pA
Sound power level (L
measured ..79.0 dB(A); K
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
This device can only be operated with
the following rechargeable batteries:
PAPK 12 A1, PAPK 12 A2, PAPK 12 B2.
This type of battery may only be charged
with the following chargers PLGK 12 A1,
PLGK 12 A2.
The noise and vibration levels have been
calculated according to the norms stated in
the conformity statement.
The stated vibration emission value was
measured in accordance with a standard
6
)
WA
2
, K= 1.5 m/s
= 3 dB
pA
)
WA
= 3.52 dB
WA
= 3 dB
pA
)
WA
= 3.81 dB
WA
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission
-1
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Try to keep the exposure to vibra-
2
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched off
and times when it is switched on but
running without any load).

Safety Instructions

This unit can cause serious in-
jury if not used correctly. Be-
fore using the unit, carefully
read through the instruction
manual and familiarise your-
self with all of its controls.

Symbols

Symbols in the manual
Warning symbols with in-
formation on damage and
injury prevention.
There is a risk of injury from
electric shock.
Instruction symbols with information
on preventing damage.