General Working Instructions; Using The Device As Grass Shears/Shrub Shears; Working With The Telescopic Arm; Cleaning/Maintenance - Parkside PGSA 12 A1 Originalbetriebsanleitung

IE NI
General working
instructions
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts.
• Comply with the device's maintenance
and cleaning instructions.
Using the device as grass
shears/shrub shears
Ensure objects such as wire, metallic
parts, stones etc. do not enter the
blades while trimming. This can cau-
se damage to the cutting unit. If the
blades become jammed with solid ob-
jects, turn the device off immediately.
• Ensure that the screws in the blade bar
are firmly in place.
• Only use sharp blades to ensure good
trimming performance and to protect
the device and rechargeable battery.
• Do not overload the device while wor-
king to such an extent that it comes to
a standstill.
Working using the grass shears
• Grass is best cut when it is dry and not
too high.
Working using the shrub shears
• Move the device in a steady forward
motion, or up and down in an arch-sha-
ped motion.
• The double-sided blade bar enables trim-
ming in both directions, or via pendulum
movements from one side to the other.
14
Working with the
telescopic arm
The telescopic arm may only
be used with the grass she-
ars blade!
During operation, make sure
that the grass shear blade
( 12) does not scrape
along the ground.
Slowly push the device on the wheels over
the ground. By doing so, you will achieve
an even cutting height.
Turn the equipment holder (
at the telescopic arm to perform a clean
cut along the lawn edge.

Cleaning/Maintenance

Leave any work not covered
in this manual to our Service
Centre. Only use original
parts. There is a risk of injury!
Remove the battery before all
maintenance work. There is a
risk of injury.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
Wear gloves when handling the
blades (
of injury from cuts!
Clean and service the unit regularly as
follows. This guarantees a long life for your
unit:
15) by 90°
10/12). There is a risk