Adjusting The Working Angle; Telescopic Arm; Switching On And Off (With Telescopic Arm); Working With The Telescopic Arm - Parkside PGSA 12 A1 Originalbetriebsanleitung

3 LEDs are on (red, yellow, green):
Battery charged
2 LEDs are on (red, yellow):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged

Adjusting the working angle

Tilting the device handgrip:
The device handgrip (4) features three
angles of inclination:
1. Operate the release (6) and tilt the de-
vice handgrip (4) to the desired angle.
2. Let go of the release (6) so that the de-
vice handgrip (4) locks into place.
Rotating the device head:
The device head (1) features 7 positions:
1. Pull the release (7) downwards and
rotate the device head (1) into the desi-
red position.
2. Let go of the release (7), the device
head (1) will lock into place.

Telescopic arm

Switching on and off
(with telescopic arm)
1. Remove the blade guard (
fore switching the device on.
2. To switch on, hold the switch lock (20) on
the handle of the telescopic arm.
3. With the switch lock pressed, push the
on/off switch (21) on the handle of the
telescopic arm.
4. Release the switch lock.
The device will run at top speed.
5. To turn off, release the on-off switch.
Working with the
telescopic arm
1. Push the device along the guide rail
into the equipment holder (15) of the
telescopic arm.
It will lock into place audibly.
2. Insert the plug (16) into the socket (17)
on the back of the device head (1).
3. Before disassembly, disconnect the
plug (16) from the socket (17).
4. Remove the device for disassembly.
Adjust the length of the telescopic arm (13)
for your size with the help of the adjusting
screw (19).
1. Loosen the adjusting screw (19).
2. Set the telescopic arm (13) to the desi-
red length.
3. Fix the position by tightening the adjus-
ting screw (19).
For a comfortable edge cut, the equipment
9/11) be- holder (15) of the telescopic arm can be
rotated by 90° to the right or left.
1. Press the release (18).
2. Turn the equipment holder into the desi-
red position.
3. The equipment holder must lock into pla-
ce audibly.
Assembling and
disassembling the device:
Adjusting the length of
the telescopic arm
Adjusting the working
angle with the telescop-
ic arm
IE NI
13