Programming; Factory Default; Parameters Overview - Camille Bauer SINEAX A210 Betriebsanleitung

Programming

All parameters may be displayed at any time. For modifi cations
the jumper on the backside of the device must be removed (not on
position LOCK).
The following table shows all parameters with their adjustable ranges
or possible selections respectively. The black numbers give a cross-
reference to the appropriate diagram position on page 30.
Starting at the measurands display by pressing the key
change to the menu level.
Afterwards you can select the desired menu item by pressing the
key shortly.
P
Use to enter the level where the desired parameter is dis played.
Pressing shortly will force the selectable element to fl ash.
P
The fl ashing content may be modifi ed using the keys
Press for a longer time to leave the parameter or menu level
P
All settings will remain non-volatile stored even in case of power-
fail.

Parameters overview

No. Topmost display
Middle display
1
2
3
4
5
6
you may
P
or
Meaning
Undermost display
(Selection,
* = Default)
System configuration
*
4-line system, unbalanced load
3-line system, unbalanced load
4-line system, balanced load
3-line system, balanced load
Single-line system
Load type for energy recovery:
Mathematical
Load type for energy recovery:
Electrical
*
Primary voltage of an external
transformer on the voltage (line-to-line
100 V to 999 kV
voltage)
*
Secondary voltage of an external
transformer on the voltage input
100 V to 999 V
(line-to-line voltage)
*
Primary current of an external
transformer on the current input
1.00 A to 999 kA
*
Secondary current of an external
transformer on the current input
0.1 A to 9,99 A
Hints:
First you have to set the system confi guration and the transformer
ratios because further measurand selections, alarm limit settings
etc. will depend on them.
The programming may be modifi ed via an optional extension mo-
dule as well.
Locking the confi guration
Place the jumper in the LOCK position.
The confi guration of all parameters is disabled.
.

Factory Default

Brightness:
.
Limit value / S01:
Limit value / S02:
Transformer ratio:
Jumper:
Connecting mode:
Synchronizing
interval:
LOCK
(mid setting)
Off
Off
1 : 1
Not in the LOCK position
4 wire asymmetric load
15 min.
Hints
(4 lines unbalanced)
(3 lines unbalanced)
(4 lines balanced)
(3 lines balanced)
(1 line)
4 quadrant display, ind-cap-ind-cap
4 quadrant display, ind-ind-cap-cap
First you enter any 3-digit number followed
by the appropriate power unit selection in
steps of factor 10
25