Camille Bauer SINEAX A210 Betriebsanleitung Seite 26

No. Topmost display
Middle display
/
7
/
8
/
9
/
10
26
Undermost display Meaning
(Selection,
* = default)
Operating mode of both digital outputs
"out.1" and "out.2"
Output switched-off
*
Energy pulse output
Alarm output
Alarm supervision source
Frequency
Neutral current
Apparent power interval
Reactive power interval
Active power interval
Power factor (cos ϕ)
Apparent power
Reactive power
Active power
Voltage
* Line-neutral voltage
Line-to-line voltage
Average current (bimetal)
Phase current
*
Alarm limit for ON-state
*
Alarm limit for OFF-state
Hints
(mode)
Simulation via interface module is still
possible
The output generates energy pulses
depending on the rate set under
The meter measurands to output may be
selected under .
11
If the alarm limit is exceeded the output
9
will be active (current flows). If the measur-
and is below limit the output will be
10
passive. The source of the monitored is
selected under .
8
This selection is presented only if operating
mode is set to ALM previously
7
Line Type
1L',
' '3Lu'
'3Lb',
'4Lb'
: 'A.on'= OR-operation of line-measurands
'A.off'= AND-operation of line-measurands
The maximum values of the alarm limits
depend on the possible measuring range
(fixed by hardware), converted into possible
primary values given by the selected system
configuration and transformation ratios.
.
12
'4Lu'