Safety Guidelines - wtw LF 320/SET Bedienungsanleitungen

This device has been built and tested according to the IEC 1010 safety standards for
electronic measuring instruments and has left our works in a condition complying with
all the requirements of technical safety.
The perfect functioning and operational safety of the instrument can only be ensured
if the user observes the normal safety precautions as well as the specific safety
guidelines stated in the present operating instruction.
- The perfect functioning and operational safety of the instrument can only be
maintained under the climatic conditions specified in the "Technical data" section
of these operating instructions.
- When the instrument is moved from cold to warm surroundings, condensate may
occur and interfere with the functioning of the instrument. In such a case, the user
should wait until the temperature of the instrument has adapted to the ambient
temperature before using the instrument again.
- Balancing, maintenance and repair work must only be carried out by a suitably
qualified technician authorized by us.
- If there is reason to assume that the instrument can no longer be employed
without a risk, it must be set aside and appropriately marked to prevent further
use.
- The safety of the user may be endangered, e.g., if the instrument
¦ shows visible damage,
¦ no longer operates as specified,
¦ has been stored over a longer period under unsuitable conditions,
¦ has been subjected to difficult conditions during transport.
- If in doubt, the instrument should as a rule be sent back to the manufacturer's -
"Wissenschaftlich-Technische-Werkstätten GmbH" - for repair and maintenance.
BA52207/03.95/Pap/LF320-SET-1
Downloaded from www.Manualslib.com

Safety Guidelines

Please read this information carefully before putting the
device into service!
manuals search engine
3