Common Faults - Sauber RVC-124120.1 Gebrauchsanleitung

4. Open the filter cover (A) to take out filter (B) and sponge (C).
5. Smack or blow the dust off the filter with cold air. Note：Filter cannot be cleaned in water.
6. Rinse the sponge under running water and dry it thoroughly before reusing it (it can be dried by cold air).
Cleaning of mopping components.
Take down the water tank with force from the bottom of the appliance. Separate the mop and water tank.
Rinse them in water and then day in shade.
Cleaning of suction inlet, side brush, wheels, cliff sensors, transparent window and the surface of the
appliance
1. Clean the suction scraper and side wall with the clean brush, which should be cleaned regularly.
2. Remove the side brushes by screwdriver, and then clean it with the clean brush and clear the
entanglement of the slot of the side brush.
3. Clean the front wheel and left/right wheels with the clean brush regularly and clear the possible
entanglements such as hair and cloth strips, of the axles of wheels.
4. Clean the cliff sensors, transparent window and product surface with a soft cloth. Do not use gasoline,
alcohol and other strong irritant cleaning lotion to clean the appliance.

COMMON FAULTS

Faulty indication
Both buttons flash red
twice with one sound
Both buttons flash red 3
times with one sound
Both buttons flash red 4
times with one sound
Both buttons flash red 6
times with one sound
Both buttons flash red 7
times with one sound
Both buttons flash red 8
times with one sound
Both buttons flash red
10 times with one sound
Both buttons flash red
11 times with one sound
Both buttons flash red
12 times with one sound
Both buttons flash red
Cold air
Fault
Failure of left wheel
Failure of right wheel
Off ground failure
Failure of anti-drop
sensor
Low electricity of battery
Failure of front bumper
Failure of side brush
Failure of wall inspection
Failure of fan
Failure of charging
Solutions
Check if there are twisters on the left wheel of the
appliance
Check if there are twisters on the right wheel of the
device
Take the appliance back to the floor. Don't have it
suspended in the air.
Check if the sensing window at the bottom of the
device is abnormally shielded.
Return the appliance to the charging base for
charging.
Check if the appliance impact buffer is normal or
not.
Check if there are things like hair or cloth twine the
side brush.
Check if the transparent window of the wall
inspection is shielded or obstructed by hair and
cloth.
Check if the blades of the fan are loose or wrapped
by hair and cloth.
The appliance cannot be powered or show the
- 33 -
Cold air