Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Totally four side brushes and four screws in the package. Fix two side brushes on the side brush slots with the
screwdrivers and two screws as shown in the figure.
Warm tip: when installing or removing the side brush, press and hold the brush holder (A) by hand to prevent
damage to the transmission machine caused by its rotation.
Before use, remove the protective strip on the bump plate to ensure the normal use of the appliance.
HOW TO CHARGE
1: Manual charging
When the cleaning is finished, turn off the appliance; use the adaptor to charge the appliance.
1) Plug one end of the adaptor into the charging port of the main unit.
2) Plug the other end of the adaptor into the power outlet.
3) During charging, the button "
4) When fully charged, the button "
Note:
During charging, all functions will be locked. The appliance will be activated when disconnect the plug.
2. Automatic recharging
1)
Place the charging base on a plane place back against the wall.
2)
Make sure no obstructions or sunken areas in the range of more than 0.5 meter on the left and right and
1.5 meters in front of the charging base.
3)
Connect the adaptor to the charger port of the charging base and then to the power outlet.
4)
Press recharge button in the main unit or remote control, the appliance will go for recharging
automatically.
Note:
a)
Put the power cord in order along the wall so as not to hinder device working.
b)
If the signal emission area on the charging base is covered or the appliance is too far to receive the signal,
the automatic recharging will fail.
c)
The appliance will automatically go for charging base when the cleaning is finished.
d)
During cleaning, if the battery is low, the appliance will automatically go for charging base.
e)
Remember to plug in the charging base; otherwise, the appliance cannot find the charging base.
f)
When the recharge button is pressed, search may fail due to too complicated surrounding obstacles or
the exhaustion of the battery.
g)
During automatic recharging, if a cleaning schedule is set, the appliance will start cleaning automatically
when the set time comes.
" will flash all the time.
" will stay lit.
- 24 -
A: main unit B: charging base
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
