Operation; Operation Via The Included Power-Unit; Inserting/Replacing The Battery; Hold-Dimmer Mode - EuroLite FD-4 DMX-Controller Bedienungsanleitung

6. OPERATION

Install the device on a plane surface.

Operation via the included power-unit

Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.

Inserting/Replacing the battery

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
With the POWER-switch, you can switch the device on and off.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.

6.1 Hold-Dimmer Mode

Call spots manually:
In the Hold Dimmer Mode, the connected spots can be called manually and be controlled via the channel
faders.
Adjust the desired function via the channel faders.
1. Turn controller ON
2. Adjust channel faders.
3. Adjust master fader for total output.
This function is useful for theatres and booth illumination.

6.2 Chaser-Sound Mode

Spots run sound-controlled through chasers:
In this mode, all 4 chasers of the FD-4/8/12 can be run sound-controlled.
You can manually adjust the individual channels via the channel faders, the Masterfader and via the flash-
buttons.
1. Turn controller ON
2. Select the desired chaser(s) by pressing the respective Chaser-button(s).
3. Adjust Masterfader for total output.
17/20 00028596.DOC, Version 1.2