Ordering Accessories; Replacing The Filter; Replacing The Side Brushes - Philips SmartPro Active FC8832 Bedienungsanleitung

Ordering accessories

Replacement

Replacing the filter

Replacing the side brushes

10 To place the TriActive nozzle, first insert the small lugs on the front into
the tiny slots on either side of the front wheel (1). Then press the catches
of the TriActive nozzle inwards to lock them into the slots in the bottom
of the robot (2). Finally, check if the nozzle can still move a few
millimeters up and down freely.
11 Push the side brushes onto the shafts on the bottom of the robot again.
To buy accessories or spare parts, visit www.philips.com/parts-and-
accessories or go to your Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the international warranty leaflet
for contact details).
Replace the filter if it is very dirty or damaged. You can order a new filter kit
under type number FC8066. See 'Emptying and cleaning the dust container'
in chapter 'Cleaning and maintenance' for instructions on how to remove the
filter from the dust container and how to place it in the dust container.
Replace the side brushes after some time to ensure proper cleaning results.
Always replace the side brushes when you notice signs of wear or damage.
We also recommend that you replace both side brushes at the same time.
You can order spare side brushes as part of replacement kit FC8068. This kit
also contains two filters and three dry wipes.
English
23