Initial Settings - Schaub Lorenz 22LT475CD Bedienungsanleitung

Initial Settings

When the TV is turned on for the  rst time, the menu
for the language selection appears on the screen. The
message "Welcome please select your language!"
is displayed in all language options sequentially in
the OSD.
By pressing the " " or " " buttons highlight the language
you want to set and press OK button.
You can get information about the menu usage by
pressing "INFO"button. Press "INFO" button again to
exit the help menu.
After then, "First time installation" OSD will appear
on the screen. By pressing " " or " " buttons, select
the country you want to set and press OK button.
Note: Country selection will not be available for UK.
Press OK to continue.
After then, the active antenna selection OSD appears
on the screen:
By pressing " " or " " buttons, set active antenna
mode as on or off.
If an active antenna is connected to your TV, you can
select this option as On. Antenna power should be
"Off" when standard antenna is used instead of the
active antenna. See "Con guration Menu" in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the "Yes" or "No" option, highlight the item
by using " " or " " buttons and press OK button.
After then, the following OSD will be displayed on
the screen:
If you select CABLE option, the following screen will
be displayed:
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
numeric buttons on the remote control. Set Start and
Stop Frequency as desired by using numeric buttons
on the remote control. After this operation, you can set
Search Step as 8000 KHz or 1000 KHz. If you select
1000 KHz, the Tv will perform search process in a
detailed way. Searching duration will thus increase
accordingly. When  nished, press OK button to start
automatic search. Automatic searching screen will be
displayed during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
If you select AERIAL option from the Search Type
screen, the digital television will search for digital
terrestrial TV broadcasts:
The IDTV will automatically tune to the UHF or VHF
(** for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about
a few minutes. To cancel searching, you can press the
"MENU" button at any time during the process.
Note: If the digital TV fails to store any channels, "No
channels available." message will be displayed on
the screen.
English - 61 -