Cable Installation; Channel Search - Schaub Lorenz 22LT475CD Bedienungsanleitung

Highlight Yes and press OK button to search for
analogue channels. The following menu appears on
the screen for analogue channel search:
Set Language item by pressing " " or " " button.
Press " " or " " button to highlight Country item and
then use " " or " " to set. Press " " or " " button to
highlight TXT Language. Select a region by using " "
or " " button. When  nished, press OK or RED button
to continue. To cancel, press the BLUE button.
After APS is  nalized, the programme table will appear
on the screen. In the programme table you will see
the programme numbers and names assigned to the
programmes.

Channel Search

In manual channel search, the number of the multiplex
is entered manually and only that multiplex is searched
for the channels. For every valid channel number,
signal level and signal quality are shown on the
screen. In both channel and auto search any existing
channel in the database is not re-stored to avoid
redundant duplicates of that channel.
Frequency Search
Enter the desired frequency. When  nished, press OK
button, and the TV will start frequency search.
Network Search
When you select Network Search line and press OK
button, the following menu screen will be displayed
on the screen:
Select YES to continue and Network Search screen
will be displayed. The process will then start.
During the Network Search, if channels that have
network search info are found, automatic search
process will end by locating those channels. After
search is completed, a message asking whether to
search for analogue channels appears on the screen.
Operation of analogue channel installation is explained
in "Automatic Channel Scan" section above.

Cable Installation

Select Cable Installation line in the Installation menu
and use OK button to view the menu contents:
Automatic Channel Scan
Automatic channel scan is started by pressing
OK button while Automatic channel scan item is
highlighted. The following message appears on the
screen:
Highlight Yes or No by using " " or " " buttons
and press OK button to con rm. If Yes is selected,
automatic search starts. Selecting No cancels
automatic search.
You can select frequency ranges from this screen. For
highlighting the lines you see, use " " or " " button.
You can enter the frequency range manually by using
the numeric buttons on the remote control. Set Start
and Stop Frequency as desired by using numeric
buttons on the remote control. After this operation,
you can set Search Step as 8000 KHz or 1000 KHz.
If you select 1000 KHz, the Tv will perform search
process in a detailed way. Searching duration will
thus increase accordingly. When  nished, press OK
button to start automatic search.
When  nished, press OK button to start automatic
search. Automatic searching screen will be displayed
during the process.
English - 69 -