Media Browser (In Dtv Mode); Playing Audio Files - Schaub Lorenz 22LT475CD Bedienungsanleitung

You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
numeric buttons on the remote control. Set Start and
Stop Frequency as desired by using numeric buttons
on the remote control. After this operation, you can set
Search Step as 8000 KHz or 1000 KHz. If you select
1000 KHz, the Tv will perform search process in a
detailed way. Searching duration will thus increase
accordingly. When  nished, press OK button to start
automatic search. Automatic searching screen will be
displayed during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
If you select AERIAL option from the Search Type
screen, the digital television will search for digital
terrestrial TV broadcasts:
The IDTV will automatically tune to the UHF or VHF
(** for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about
a few minutes. To cancel searching, you can press the
"MENU" button at any time during the process.
Note: If the digital TV fails to store any channels, "No
channels available." message will be displayed on
the screen.
Either you select AERIAL or CABLE option from the
search type menu, after the digital automatic search
is completed, the following message asking for
analogue channel search appears on the screen:
Operation of analogue channel installation is explained
previously in "Initial Installation" section.

Media Browser (in DTV mode)

Whenever you plug a USB  ash disk to your TV, the
following message will be displayed on the screen:
Select YES or NO by pressing " " or " " button and
"OK" button to continiue.
You can also select Media Browser item from the main
menu by using " " or " " buttons. Press OK to view
Media Browser contents.
You can play audio and photo  les from a USB  ash
disk.
Note: Some USB compliant devices may not be
supported.
Note: Movie Sense and Pixellence features cannot
be set while in Media Browser mode.
Note: If you plug USB stick in analogue mode, the TV
will automatically switch to digital TV mode.
Note: If the USB stick is not recognized after Power
off/on or First Time Installation,  rst plug the USB
device out and power off/on the TV set. Plug the USB
device again.
Press OK to browse, "MENU" to quit.

Playing Audio Files:

Play This (OK) : Plays the selected  le.
Play ( ) : Play all media  les in the folder starting
with the selected one.
Pause/Resume (
playback.
Stop ( button) : Stop the playing  le.
Previous/Next ( / ) : Jumps to previous or next
 le to play.
English - 71 -
button): Pauses or resumes