First Time Installation - Schaub Lorenz 22LT475CD Bedienungsanleitung

Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
After search is completed for digital channels, a
message asking whether to search for analogue
channels appears on the screen: Operation of
analogue channel installation is explained in
"Automatic Channel Scan" section above.
Frequency Search
Enter the desired frequency, Modulation and symbol
rate numbers. Modulation can be set as Auto, 16QAM,
32QAM, 64QAM, 128QAM and 256QAM.
When  nished, press OK button, and the TV will start
frequency search.
Network Search
When you select Network Search line and press OK
button, the following menu screen will be displayed
on the screen:
Enter Start and Stop frequency ranges that you
want to search within. After this operation, you
can set Search Step as 8000 KHz or 1000 KHz.
If you select 1000 KHz, the Tv will perform search
process in a detailed way.Searching duration will
thus increase accordingly. When  nished press OK
button to continue. The process will then start. During
the Network Search, if channels that have network
search info are found, the TV will automatically show
the frequencies of those channels and network search
process will end by locating those channels.
After search is completed, a message asking whether
to search for analogue channels appears on the
screen: Operation of analogue channel installation
is explained in "Automatic Channel Scan" section
above.
Clear Service List (*)
(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press "
" or " " button to select Clear Service List and then
press OK. The following OSD will be displayed on
the screen:
Press OK to cancel. Select Yes by pressing " " or " "
button and press OK to delete all of the channels.

First Time Installation

The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight "First Time
Installation" menu item and press OK button, then
you will be asked whether or not to delete the settings.
Selecting "Yes" by pressing OK button will delete the
existing channel table.
After factory settings are loaded, "First Time
Installation" menu will be displayed.
The menu which is displayed for language selection
appears on the screen at  rst. By using " " or "
" buttons, select the desired language option,
and press OK button to activate. After then, "First
time installation" OSD will appear on the screen.
By pressing " " or " " buttons, select the Country
you want to set and press OK button (* only for EU
countries). Next, active antenna mode selection OSD
will appear on the screen. Use " " or " " to set and
press OK to continue. See the section, "Initial Settings"
for more information. After active antenna mode option
is selected, a message asking for automatic search
appears on the screen:
Highlight "Yes" item by pressing " " or " " buttons
and press OK button to start installation. • To select
the "Yes" or "No" option, highlight the item by using "
" or " " buttons and press OK button.
After then, the following OSD will be displayed on
the screen:
If you select CABLE option, the following screen will
be displayed:
English - 70 -