Operation With The Remote Control; Programme Selection (Previous Or Next Programme); Initial Settings; General Operation - Schaub Lorenz 26LT30 Bedienungsanleitung

Operation with the Remote Control

• The remote control of your TV is designed to control
all the functions of the model you selected. The
functions will be described in accordance with the
menu system of your TV.
• Functions of the menu system are described in the
following sections.
Volume Setting
• Press "V+" button to increase the volume. Press "V-"
button to decrease the volume. A volume level scale
(slider) will be displayed on the screen.
Programme Selection (Previous or Next
Programme)
• Press " P - " button to select the previous programme.
• Press " P + " button to select the next programme.
Programme Selection (Direct Access)
• Press numeric buttons on the remote control to select
programmes between 0 and 9. The TV will switch
to the selected programme. To select programmes
between 10-500 (for IDTV) or 10-199 (for analogue),
press the numeric buttons consecutively
• Press directly the programme number to reselect
single digit programmes.

Initial Settings

When the TV is turned on for the fi rst time, the menu
for the language selection appears on the screen. The
message "Welcome please select your language!" is
displayed in all language options sequentially in the
OSD.
By pressing the " " or " " buttons highlight the language
you want to set and press OK button. After then, "First
time installation" OSD will appear on the screen. By
pressing " " or " " buttons, select the country you want
to set and press OK button (* for EU countries).
Note: Country selection OSD will not be available for UK.
Press OK button on the remote control to continue and the
following message will be displayed on the screen:
• To select the "Yes" or "No" option, highlight the item by
using " " or " " buttons and press the "OK" button.
The IDTV will automatically tune to the UHF or VHF(*)
(* for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
02_MB45M_[GB]_3920UK_IDTV_NICKEL12_26743W_10070864_50178999.indd 54 02_MB45M_[GB]_3920UK_IDTV_NICKEL12_26743W_10070864_50178999.indd 54
names of channels found. This process will take about
a few minutes.
After Automatic Search is completed, the following
message asking for analogue channel search appears
on the screen:
To search for analogue channels, select "Yes". TV
switches to the analogue TV mode. The menu is
displayed to search for analogue channels.
Select your Country, Language and Text language by
using " " or " " and " " or " " buttons. Press OK or
RED button to continue. To cancel, press the BLUE
button.
For more information on this process, see "Install Menu"
section.
Note : For proper functioning of digital teletext in DTV mode, you
should set country as UK in analogue AUTO PROGRAM (for UK
broadcasts only).
Do not turn off the TV while initializing fi rst time installation.

General Operation

Press the "SOURCE" button on the remote control
and select DTV to switch the TV set to digital terrestrial
television broadcasting.
Information Banner
• Whenever you change channel, using the P- / P+ button
or the numeric buttons, the TV displays the broadcast
picture along with an information banner at the bottom
of the screen (available only in DTV mode). This will
remain on the screen for a few seconds.
• The information banner can also be displayed at any
time while watching TV by pressing the "INFO" button
on the remote control:
English - 54 -
27.10.2010 15:39:29 27.10.2010 15:39:29