SecaCam Raptor mobile Bedienungsanleitung Seite 48

Press "PUSH" to open battery compartment
"PUSH" on the cover to open it. Insert four fully-charged batteries- pay close
attention to the battery polarity written on the compartment door! Close the
battery compartment by pressing down the protective cover until the lock
engages. Close the base plate and tighten the brass screw again.
Back battery compartment in holder: The second set of four batteries has
to be inserted into the holder. To do so, open the protective cover of the back
battery compartment in the rear part of the camera housing by pulling the
clip on the bottom slightly inward and then lifting off the cover. Insert four fully
charged batteries. When inserting the batteries, please make sure that the
camera is turned off and the polarity fits the marking in the battery compart-
ment. Finally, close the cover of the back-battery compartment.
48
Bottom battery compart-
ment: The main battery
compartment is accessible
through the base plate of
the camera. To open the
plate, unscrew the small
brass screw. You will see
the battery compartment
cover after folding away the
base plate. Lightly press
Compartment screw
(optional)
Back battery compartment plug
Locking brackets
Battery compartment
Compartment screw
(optional)
3. Set up