Installation - DeLonghi HVE 130 Bedienungsanleitung

HVE 130.qxp 15-09-2003
GB
Voltage/ Wattage
ELECTRICAL CONNECTION
- Before plugging in the heater, check that the voltage of your domestic supply corresponds to the
voltage (V) indicated on the appliance.
- Check that the electrical socket has a rating of 10/16 Amps.
- THIS APPLIANCE COMPLIES WITH EEC DIRECTIVE 89/336, RELATING TO ELECTRO-MAGNE-
TIC COMPATIBILITY.

INSTALLATION

The appliance requires no installation, it should be used solely as a portable appliance.
Portable appliances are not suitable for use in a bathroom.
FUNCTIONING AND USE
Models with function selector and thermostat
Operating the function selector
- Summer use (ventilation only): turn the thermostat dial clockwise to the
- Min power operation: turn the function selector dial to position 1 .
- Max power operation: turn the function selector dial to position 2.
- Switching the appliance off: turn the function selector to position "● " and the thermostat in
the then pull the plug from the electrical outlet.
REGULATING THE THERMOSTAT
When the room has reached the required temperature turn the right thermostat knob
included) in an anti-clockwise direction up to the point where the appliance switches off and not
beyond. The temperature fixed in this way will be automatically regulated and kept at a constant
level by the thermostat.
ANTIFREEZE SERVICE
Turn the left functin selector 1 to setting 2, then turn the right thermostat knob
When it is set in this way the appliance keeps the room at a temperature of approx. 5° C with mini-
mal energy expenditure.
Models with function selector only
Summer service (ventilation only): turn the function selector
Heating at reduced power: turn the function selector
Heating at full power: turn the function selector
Switching off: turn the function selector
CLEANING AND MAINTENANCE
Before cleaning always remove the plug from the electrical socket.
Clean the air inlet/outlet grilles frequently.
Never use abrasive powders or solvents.
WARNINGS
- Do not use the appliance in the vicinity of showers, bath tubs, wash basins, swimming pools, etc.
- Always use the heater in an upright position.
- Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger of overhea-
ting).
- The heater must be positioned at least 50 cm from furniture or other objects.
- When the appliance is used in portable version, do not place it up against walls, furniture, curtains, etc.
- Replacement of the feed cable must be entrusted only a technician authorised by the manufacturer, becau-
se such work requires special tools.
- The appliance must not be positioned directly underneath a fixed power point.
- Do not cover the appliance while it is functioning in order to avoid overheating with the attendant risk of
fire.
- Do not use the appliance in rooms less than 4 m
The heater is fitted with a safety device which will switch off the heater in case of accidental overhea-
ting (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, disconnect the
plug from the power for a few minutes, remove the cause of overheating then plug the appliance in again.
Important: never cover this appliance in any manner whatsoever while it is ope-
rating. To do so would cause a dangerous increase in the temperature of the
appliance itself.
16:30 Pagina 2
See rating label
/6 position.
2
1 to setting
to setting 1.
1
to setting 2.
1
to setting 0.
1
in area.
2
(where
2
to setting .
.