Electrical Connections; Installation - DeLonghi DCH2590ER Bedienungsanleitung

ELECTRICAL CONNECTIONS

- Before plugging into the mains, make sure the voltage of your mains supply corresponds to
the V value indicated on the appliance and that the socket and power line are appropriate
for the load required.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 89/336/EEC ON RADIO INTERFERENCE
SUPPRESSION.

INSTALLATION

The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same socket for other appliances.
DESCRIPTION
A "Stand-by" and swing button
B Pulse MODE
C SET TIME button
D ON light
E Motorised rotating base
F Temperature adjustment button
G POWER, stand-by button (remote control)
H Swing button (remote control)
I ON/OFF switch
OPERATION AND USE
1. Make sure the appliance is off before plugging into the mains
2. To turn the appliance on, the switch at the back must be in the I position. The appliance emits a
beep. The "ON" light also comes on and remains lit while power to the appliance is on.
3. Press button A to turn the appliance on.
4. The appliance starts up in LOW mode (minimum heat output). The display shows room tem-
perature.
5. Press the MODE button (B) to switch to HIGH mode (maximum heat output). The display
shows room temperature.
6. Press the MODE button (B) again to switch the appliance to AUTO mode.The set temperatu-
re flashes and can be modified using the + and - buttons. After a few seconds, room tem-
perature is shown on the display.
7. Press the MODE button (B) a fourth time to switch the appliance back to LOW mode. When
the MODE button is pressed continuously, the appliance switches through the following
modes in sequence: LOW
8. To turn the appliance off, press button A for a few seconds and place the switch on the
back in the 0 position.
Adjusting the thermostat
1. Press the MODE button (B) until AUTO is displayed.
2. Use the + and – buttons (or F on the remote control) to increase or reduce the temperature
set point The thermostat will then keep room temperature at the selected level automatical-
ly.
3. When room temperature is 2°C above the set temperature, the appliance goes off.
4. When room temperature drops below the set temperature, the appliance comes on automatically.
Frost prevention mode
You can keep the room at a temperature of about 5°C to prevent freezing with minimum energy con-
sumption.
Press the MODE button (B) until AUTO is displayed. Press the "
of 5°C.
When the room temperature drops below the set temperature, the appliance comes on automatically.
HIGH AUTO.
-
" button to select a temperature set point
GB
7