Installation; Maintenance - DeLonghi RCH100 Bedienungsanleitung

GB
ELECTRICAL CONNECTION
- Before plugging into the mains, make sure the voltage of your mains supply corresponds to
the V value indicated on the appliance and that the socket and power line are appropriate
for the load required.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 89/336/EEC AND D.M. 476/92 ON
RADIO INTERFERENCE SUPPRESSION.

INSTALLATION

The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same socket for other appliances.
OPERATION AND USE
TURNING ON
Plug the appliance into the mains socket and turn the thermostat knob to maximum.
- Place the switch in the I position to select minimum power.
- Place the switch in the II position to select maximum power.
In both positions, the indicator light comes on.
TURNING THE APPLIANCE OFF
To turn the appliance off, place the switch in the "0" position.
Adjusting the thermostat
When the room has reached the required temperature, turn the thermostat dial slowly anti-
clockwise until the light goes out and no further.
The thermostat will then keep room temperature at the selected level automatically.

MAINTENANCE

- Always unplug from the mains socket before cleaning.
- During the season when the appliance is in use, clean the air intake and outlet grilles
regularly using a vacuum cleaner.
- Never use abrasive powders or solvents.
IMPORTANT
- Do not use the heater near bathtubs, showers or swimming pools.
- Always use the heater in an upright position.
- Do not use the heater to dry laundry.
- Never obstruct the intake and outlet grilles (danger of overheating).
- Do not allow children or unfit persons to use the appliance without adequate supervision.
- Do not allow children to play with the appliance.
- The heater must be positioned at least 50 cm from furniture or other objects.
- Do not use the appliance near walls, furniture, curtains, etc.
- The use of extension leads is not recommended.
However if they cannot be avoided, follow the instructions accompanying the extension
lead and never exceed the power limit marked on the extension.
6