Installation Requirements For Electrical Connection - GUTMANN NIVEL Montageanleitung

EN
9. MOUNTING REQUIREMENT -
WARNING AGAINST ELECTRICAL
TENSION!
THERE IS DANGER TO LIFE !
There are energised parts near this
symbol. Covers marked with this symbol
may only be removed by an authorised
electrician.
• The electrical connection may only be
carried out by an authorised specia-
list!
• The statutory regulations and connec-
tion conditions of the local electrical
supply company must be observed in
full.
• When the device is connected, a de-
vice must be provided which makes it
possible to disconnect the device
from the mains with an opening width
of at least 3 mm all poles using a
contact. LS switches, fuses and
contactors are regarded as suitable
disconnecting
connecting and repairing the device,
disconnect it from the power supply
using one of these devices.
• The protective conductor must be long
enough so that if the strain relief fails,
it will only be subjected to tensile
stress after the current-carrying cores
of the connecting cable.
• The excess cable length must be pul-
led out of the installation area below
the device.
• Please make sure that the mains vol-
tage is the same as on the namepla-
te.
• Complete protection against acciden-
tal contact must be ensured by instal-
lation.
• Attention: Incorrect connection can
lead to destruction of the power
electronics.
• The device is only approved for per-
manent installation. It must not be
connected with a safety plug.
44
devices. When
ELECTRICAL CONNECTION
Connected loads:
Cooker hob Mains voltage:
380-415V 3N~, 50/60Hz
Extractor hood Mains voltage:
220-240V 50Hz
( see also instructions cooktop )
Connecting cable built in by factory
• The hob is equipped with a tempera-
ture-resistant connection cable at the
factory.
• The mains connection plug of the
extractor fan is already present.
• Damaged lines may only be replaced
by the manufacturer or his customer
service.
: