IKEA SKINANDE AA-2003812-5 Bedienungsanleitung Seite 12

ENGLISH
3. Press repeatedly to change the
setting.
4. Press the on/off button to confirm the
setting.
The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the rinse
aid indicator is turned on notifying to refill
rinse aid. If the drying results are
satisfactory while using multi-tablets only, it
is possible to deactivate the notification for
refilling rinse aid. However, for best drying
performance, always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid empty
notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
the indicators
start flashing and the display is blank.
2. Press
• The indicators
• The indicator
• The display shows the current setting.
– = rinse aid empty notification
activated.
– = rinse aid empty
notification deactivated.
3. Press
4. Press on/off to confirm the setting.
and until
, , and
.
, and are off.
still flashes.
to change the setting.
Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is complete. This
acoustic signal is activated by default and
you can deactivate it.
When you press the main switch to turn on
the dishwasher, it makes a short beep
sound. The beep is activated by default and
you can deactivate it along with the
acoustic signal for the end of a programme.
In addition, an acoustic signal sounds
before the AutoOpen opens the door. This
acoustic signal stops only if AutoOpen is
deactivated.
How to deactivate the acoustic signals
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
the indicators
flash and the display is blank.
2. Press .
• The indicators
are off.
• The indicator
• The display shows the current setting:
– = Acoustic signal off.
– = Acoustic signal on.
3. Press to change the setting.
4. Press on/off to confirm the setting.
AutoOpen
AutoOpen improves the drying results with
less energy consumption.
and until
, , and
, and
still flashes.
12