Closing The Door; Replacing The Lamp; Installation - Electrolux ENN2853COW Benutzerinformation

Problem
The temperature in the ap‐
pliance is too low/too high.

7.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

8. INSTALLATION

8.1 Location
To ensure best performance, install the
appliance well away from sources of heat
such as radiators, boilers, direct sunlight
etc. Make sure that air can circulate
freely around the back of the cabinet.
Downloaded from www.Manualslib.com
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
Refer to the assembly
instructions for the
installation.
manuals search engine
Possible cause
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The Shopping Fast‐
Freeze mode is switched
on.
There is no cold air circu‐
lation in the appliance.

7.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
8.2 Positioning
Install the appliance in a dry, well
ventilated indoors where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance.
Climate
class
SN
ENGLISH
Solution
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "Shopping Fast‐
Freeze mode".
Make sure that there is cold
air circulation in the appli‐
ance.
Ambient temperature
+10°C to + 32°C
35