bürkert 8640 Kurzanleitung

DeviceNet, IP 65 with jumper
General overview IP 65
LED-status
display
DIP
switches
Fig: General overview of field bus module DeviceNet IP 65
NOTE
The Dip switches can be operated through the film!
Power supply IP 65
The 4-pole circular connector for the power supply has the following configuration:
Fig: Structure of the power supply
NOTE
The power supply must be protected with following fuses
- Pin 1 with 3 A (semi-time-lag)
- Pin 2 with 1 A (semi-time-lag)
ATTENTION!
To assure electromagnetic compatibility (EMC), screw terminal FE
(functional earth) should be connected to earth potential with as
short a cable as possible (30 cm).
Power
supply
Functional
earth
Field bus
connection
Pin 1 + 24 V - driver
(outputs)
Pin 2 + 24 V - logic
Pin 3 GND
Pin 4 GND