Remote Control - Honeywell MN Serie Benutzerhandbuch

USE & OPERATION (CONTINUED)

REMOTE CONTROL

The functions work the same as the Local Air Conditioner's Control Panel.
All key functions can be accessed from the remote control.
Power Control
ON / OFF
Fan Speed Control
• HIGH • MID • LOW
Timer Control
In running mode: Auto switch off
In stand-by mode: Auto switch on
Press ▼ or ▲ button to adjust the
time setting for 1 hour intervals.
Note:
• Battery Installation: Remove the cover on the back of the remote control and insert two AAA
batteries with + and - pointing in the proper direction according to the polarity markings.
Caution:
• Use only two AAA or IEC R03 1.5V batteries.
• Remove the batteries if the remote control is not in use for a month or longer.
• All batteries should be replaced at the same time, do not mix with old batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
• Properly dispose of used batteries.
Temperature / Timer Set
• Used for adjusting the timer and
temperature.
When the ▼ or ▲ key is pressed, the
•
set temperature is displayed and
may be adjusted
• Timer setting is available from 1 - 24 hours
by pressing the key ▼ or ▲.
Press this button to change the operation
mode in the order of:
Air Conditioning
*Applicable for models with Heating feature only.
EN 10
Mode Control
Dehumidifying
Fan
Heating*