Herunterladen Inhalt Inhalt Diese Seite drucken

Remote Control - Honeywell CL25AE Benutzerhandbuch

Tragbare verdunstungs luftkühler
Vorschau ausblenden Andere Handbücher für CL25AE:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
TIMER
Press the TIMER button until the desired time duration setting is selected. When the set time has
passed, the unit will automatically turn off (unit remains in Standby mode until power cord is unplugged
from electrical socket). The TIMER function allows you to program the unit for up to 7.5 hours of use.
SWING
Press the SWING button until the SWING indicator light is illuminated on the control
panel. The louvers will begin to move left to right automatically.
Vertical Air Flow - You can manually adjust the louvers to change vertical air flow.
MODE
Press the MODE button to select COOL and FAN modes. Pressing the MODE button until COOL is
illuminated on the control panel activates evaporative cooling. The water pump will operate and you will
feel the cooler air after the Honeycomb Cooling Media is completely wet.
Pressing the MODE button until Fan is illuminated switches the unit to a fan only mode, without
evaporative cooling.
ROOM COOLING AND HUMIDIFYING
In cooling mode, Honeywell Air Coolers provide moisturized air through the
evaporation of water. There is a manual Water Regulator knob located in
the ice compartment of the unit. This allows you to adjust the amount of
water pumped over the Honeycomb Cooling Media, thus helping to control
cooling and humidification levels.
When the Water Regulator is set to MIN, the water pump distributes a
minimal amount of water to the Honeycomb Cooling Media. This results in
less water evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes the maximum amount of water to
the Honeycomb Cooling Media. This results in maximum water evaporation and the cooling performance
improves.

REMOTE CONTROL

POWER
SPEED
SWING
MODE
TIMER
Note:
The remote control requires AAA (2 x 1.5V) batteries for replacement.
Open the battery compartment at the back of the remote control and insert the batteries inside. Care
must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside
the battery compartment.
Always point the remote control signal transmitter towards the unit when operating. Make sure that
the signal path is not obstructed.
Remove the batteries if the unit is not going to be used for an extended period of time.
Do not drop the remote control.
POWER
: ON / OFF
SPEED
: Low / Medium / High / Sleep*
MODE
: Controls cooling or fan option
SWING
: Controls the motion of the louvers
TIMER
: Controls the Timer function for automatic off
EN
*Applicable for models with Sleep feature only.
2
LOUVER
MOVEMENT
Water Regulator
MIN
MAX

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis