Honeywell MN Serie Benutzerhandbuch Seite 13

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
• Fan Mode
For air circulation without air conditioner cooling.
• *
Heating Mode
This unit uses Heat-Pump technology which reverses the air conditioning cooling cycle by
transferring heat from the outside into the room – this is more energy efficient than traditional
electric heaters that generate heat instead of transferring heat into the room. These properties
make this heater ideal for use in autumn or spring when outdoor temperatures are not severely
cold, or as supplemental heating in colder rooms of your home.
When heating mode is selected the indicator light will shine. Ambient temperature range is
10'C - 25'C (50'F - 77'F). Heating is activated only when the ambient temperature is below
25°C (77°F). In this mode, the desired temperature can be set between 16°C- 25°C (61°F -
77°F).
Note: The exhaust hoses must vent outside the room when using heating mode.
IMPORTANT: The Heat pump draws moisture from the air which then condenses into the
internal water tank. The unit will pause operation when the tank is full and will restart when
the tank has been emptied. It is recommended to use the heating mode in a room with 50%
humidity or lower. Avoid operating moisture-producing products or appliances such as a
humidifier or a kettle when using the unit in heating mode.
See the "Draining Water Condensation in Heat Mode" section for more information on draining
the water tank.
FAN SPEED CONTROL
3 settings: High, Medium and Low.
*Applicable for models with Heating feature only.
EN 8