Maintenance; 3-Technical Specifications; Product Identification; Product Description - CAMPAGNOLA PUMA Gebrauchs- Und Wartungsanweisung

Attention!
For all the information and warnings about the Step-Up 12V-18V converter for the 12V lead battery check its own
instructions.

2.3 Maintenance

Warning!
Before performing any maintenance operations or adjustments of the mechanical parts of the equipment, wear protective
shoes, gloves and goggles.
• Routine maintenance and repairs can be carried out only by an operator with the necessary physical and intellectual
qualifications.
•
Special maintenance and repairs can be carried out only by a service mechanic.
•
Keep bystanders away when servicing or repairing the machine.
•
Only service mechanics are authorized to disengage the product safety devices, when maintenance is to be performed. It
is their responsibility to safeguard the operators and the product. The safety devices shall be activated as soon as
maintenance work has been completed.
•
All maintenance procedures not dealt with in this manual are to be performed at a CAMPAGNOLA S.r.l. Authorized Service
Point.
• When maintenance or repairs have been completed, the machine can be started again only if duly authorized by a service
mechanic, who must make sure that:
- the operations have been ended up;
- the machine runs in a trouble-free way;
- the safety devices are engaged;
- no one is working on the machine.
3- TECHNICAL SPECIFICATIONS

3.1 Product identification

The tool details are indicated on the identification sticker (19).

3.2 Product description

The pneumatic chain pruner is a tool which is used for cutting and pruning orchards, vineyards, citrus and olive trees and
similar plants.The tool can be operated by two 12V battery kinds: either a lead or a lithium battery, the latter being carried in its
own backpack. The battery capacity (Amps) only determines the working autonomy.
It is fitted with an ergonomic handle (1), a motor housing (17) in light alloy and an 8" bar (14) with ¼" chain (15).
The handle (1) is endowed with an ON/OFF switch (4), an operating lever (5) and an active safety device (6), automatically
engaging itself when the lever (5) is released. An inertial chain brake (12) (only tool model without extension pole) protects the
operator from possible dangerous kickbacks while working. This safety device stops the chain (15) of the bar (14)
immediately. Moreover, there is a connector (7) mounted on the handle (1) which connects the tool to the battery by means of
a power supply cable (11). The cable is either 10 m long, fitted with connecting clamps, for the lead battery, or 1.5 m long for
the lithium battery.

3.2.1. Chain pruner connected to an extension pole

The chain pruner can be supplied either with a fixed (25) or with a medium or long telescopic (26) extension pole.
It is fitted with an ergonomic handle (1), an extension pole, a light-alloyed motor housing (17) and a 8" bar (14) with ¼" chain
(15).

3.3 Supplied parts

Use & Maintenance Manual.

3.4 Recommended use

The chain pruner has been designed for cutting and pruning according to the above-described manners and limits.