Installing The Mulch Plug Or The Grass Bag - Toro 20899 Bedienungsanleitung

2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait 3 minutes for the oil to settle in the engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
7. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5 through 7 until the oil on the dipstick is at
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Engine Oil (page
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
Important:
Change the engine oil after the first 5
operating hours; change it yearly thereafter. Refer
to Changing the Engine Oil (page
(Figure
Figure 6
3. Add
(Figure
Changing the
18).
18).
4
6).
Installing the Mulch Plug or
the Grass Bag
No Parts Required
Procedure
You must correctly install either the mulch plug (for
recycling or side-discharging the grass clippings) or
the grass bag; otherwise, the engine will not start.
The machine has a safety switch (located at the
bottom of the channel on the upper right rear of the
machine) that prevents the machine from operating
without a mulch plug or a grass bag in place. This
prevents the machine from throwing debris at you
g232743
through the rear opening.
For the switch to detect the mulch plug, the top of the
mulch plug lever must lie fully in the bottom of the
channel (Figure
6).
1. The top of mulch plug lever in the switch channel
1. Insert the mulch plug into the machine if it is not
already installed
5
7).
Figure 7
(Figure 8).
g005324