Safety Instructions - Jung Pumpen Pentair U3K/2 Originalbetriebsanleitung

ENGLISH
You have purchased a product made by JUNG
PUMPEN and with it, therefore, also excellent
quality and service. Secure this service by carry-
ing out the installation works in accordance with
the instructions, so that our product can perform
its task to your complete satisfaction. Please re-
member that damage caused by incorrect instal-
lation or handling will adversely affect the guar-
antee.
Therefore please adhere to the instructions in
this manual!
As with all electrical devices, this product can
also fail to operate due to an interruption in the
electricity supply or due to a technical defect. If
this could result in damage, a mains-independ-
ent alarm system must be installed. Depending
on the application, you may also wish to install an
emergency power generator, or a second system
as a back-up.

SAFETY INSTRUCTIONS

This instruction manual contains essential in-
formation that must be observed during instal-
lation, operation and servicing. It is therefore
important that the installer and the responsi-
ble technician/operator read this instruction
manual before the equipment is installed and
put into operation. The manual must always be
available at the location where the pump or the
plant is installed.
Failure to observe the safety instructions can lead to
the loss of all indemnity.
In this instruction manual, safety information is dis-
tinctly labelled with particular symbols. Disregard-
ing this information can be dangerous.
General danger to people
Warning of electrical voltage
ATTENTION! Danger to equipment and operation
Qualification and training of personnel
All personnel involved with the operation, servicing,
inspection and installation of the equipment must
be suitably qualified for this work and must have
studied the instruction manual in depth to ensure
that they are sufficiently conversant with its con-
tents. The supervision, competence and areas of
responsibility of the personnel must be precisely
10 10
regulated by the operator. If the personnel do not
have the necessary skills, they must be instructed
and trained accordingly.
Safety-conscious working
The safety instructions in this instruction manual,
the existing national regulations regarding accident
prevention, and any internal working, operating and
safety regulations must be adhered to.
Safety instructions for the operator/user
All legal regulations, local directives and safety reg-
ulations must be adhered to.
The possibility of danger due to electrical energy
must be prevented.
Leakages of dangerous (e.g. explosive, toxic, hot)
substances must be discharged such that no danger
to people or the environment occurs. Legal regula-
tions must be observed.
Safety instructions for installation, inspection
and maintenance works
As a basic principle, works may only be carried out
to the equipment when it is shut down. Pumps or
plant that convey harmful substances must be de-
contaminated.
All safety and protection components must be re-
fitted and/or made operational immediately after
the works have been completed. Their effectiveness
must be checked before restarting, taking into ac-
count the current regulations and stipulations.
Unauthorised modifications, manufacture of
spare parts
The equipment may only be modified or altered in
agreement with the manufacturer. The use of origi-
nal spare parts and accessories approved by the
manufacturer is important for safety reasons. The
use of other parts can result in liability for conse-
quential damage being rescinded.
Unauthorised operating methods
The operational safety of the supplied equipment
is only guaranteed if the equipment is used for its
intended purpose. The limiting values given in the
"Technical Data" section may not be exceeded under
any circumstances.