Inhaltsverzeichnis
Werbung
Readout setup
Fig 69
50
14
15
16
Fig 68
Fig 70
PPS10 Pocket Scope
14 WAC
The AC rms power is calculated on the cho-
sen load.
15 Wpeak
The peak power is calculated on the chosen
load.
16 WAC+DC
The AC+DC power is calculated on the
chosen load.
Remark:
•
If the signal goes off-screen or is too small
for dB measures, the readout will indicate
'???' (fig. 69).
•
Make sure that at least one or two periods are
displayed for all AC measures.
•
Hide the readout via 'none'.
•
Up to four readouts can be shown on the
display, depending on the chosen display
layout.
•
Some readouts have more digits (precision)
when they are shown on the left side of the
display.
•
With a time base of 1s/div or slower, only
the instant value (Vs) will be shown (fig. 70).
TM
Werbung
Inhaltsverzeichnis
