Maintenance - Vacmaster Orson Lite VSE2101EU Bedienungsanleitung

GB
CAUTION:
remove the charging adapter from the vacuum cleaner before any maintenance.
WARNING!
1. Emptying the Dust Bin
NOTE: For best performance, empty dust bin after every use or once dust reaches MAX fill line.
Before emptying the dust bin, ensure the vacuum cleaner is turned off.
1) Position dust bin area of vacuum over a waste receptacle. Press down on the dust bin door
release button to open dust bin lid and allow bin contents to drop into waste receptacle (Fig. 17).
2) Close the dust bin door until you hear a click.
2. Cleaning the Filters
NOTE: The key to maximum performance is having a clean filter. Cleaning the filter frequently will
help your vacuum cleaner operate at peak efficiency. A spare filter is provided with your vacuum
cleaner to allow you to dry one filter properly while using the other. Additional filters can be
purchased from www.cleva-europe.com.
1) With one hand grasped around the handle, press the motor head release button to separate
the dust bin from the handheld vacuum (Fig. 18).
NOTE: Grasp the dust bin when pressing the release button.
2) Remove the filter and filter cage from the dust bin (Fig. 19).
3) Use a soft brush to clean loose debris from the filter and then rinse with warm water. Rinse and
gently squeeze dry the filters. Set all filters aside and allow to air dry for 24 hours.
IMPORTANT: The filters and the filter cage must be completely dry before reuse.
4) Place the filter cage back into the dust bin, then place the filter back in.
5) To reassemble the dust bin to the handheld vacuum, align the tabs on the dust bin with slots in
the handheld vacuum. Once aligned, attach the dust bin to the handheld vacuum until you hear
a click (Fig. 20).
3. Cleaning the Motorised Floor Head & Blockage
Remove the Brush Roll
1) Make sure the vacuum cleaner is turned OFF, then remove the wand and set aside.
2) Turn the floor head over to access the brush roll. Press and push the tab on the left hand side
of the head to the left and hold it. This will unlock the brush roll (Fig. 21).
3) With the tab pushed to the left, simply lift the brush roll out of the head housing. Clean off debris
and anything wrapped around the brush roll. Use a pair of scissors to remove threads, etc.
4) Place the brush roll back into the housing by aligning the hexagonal end of the brush roll into
the right end of the head. Then push the unlock tab to the left and hold it. Align the square end
of the brush roll with the left end of the head and insert it into place (Fig. 22). Release the tab to
lock the brush roll.

MAINTENANCE

To reduce the risk of electric shock, turn the vacuum cleaner off and
Do not operate the vacuum cleaner without filters in place.
10