Concept CP 2000 Bedienungsanleitung Seite 56

EN
OPERATING INSTRUCTIONS
Assembly
Remove all components from the packaging.
1. lnsert the handle into the cleaner main body until it locks into position
(1).
2. Assemble the main body of the cleaner to the Floor Head (2).
Use
BEFORE THE FIRST USE
1. Press the Water Tank Release Button and remove the tank (3).
NOTE: A tube feeding water from the water tank to the boiler is loaded with
a brass ball. This design is intentional and serves to increase the efficiency
of water use.
It is normal for this ball to create a rattling sound inside the Water Tank
during operation.
2. Pull the Water Tank by the cap (4).
3. Fill the tank with cold tap water. Secure the tank with the cap (4). Do
not add any chemicals, detergents or perfumes to the Water Tank.
NOTE: We recommend using distilled or de-mineralized water in order to
reduce building up mineral deposits and prolonging the life of the appliance.
4. Put the Water Tank back in its place and make sure the Water Filter is
installed.
5. Attach the Textile Pad on the bottom of the Head (5).
IMPORTANT: Always disconnect the appliance from the mains prior to
adding water or changing the Textile Pad.
NOTE: Wash the Textile Pad before putting on the appliance, it prevents
a presence of any loose fibres.
FLOOR CLEANING
NOTE: Always vacuum or sweep the floor prior to use the steam cleaner.
IMPORTANT: Do not use the cleaner without the Textile Pad attached to
the Head.
NOTE: Do not use the Carpet Glider for cleaning hard floor types.
56 CP 2000