Concept CP 2000 Bedienungsanleitung Seite 57

1. Connect the steam cleaner into the mains. Press the power on/
off button, the indicator will light blue.
2. After a few seconds half of the indicator will tum red, meaning the
appliance is ready for use.
3. Put your foot on the head and angle the body of the cleaner downwards
(6).
4. Press the trigger to release the vapour (7).
5. Move the cleaner slowly backwards and forwards paying particular
attention to frequently used areas.
CARPET CLEANING
NOTE: Always vacuum or sweep the floor prior to use the steam cleaner.
IMPORTANT: Do not use the cleaner without the Textile Pad attached to
the Head.
1. Attach the Carpet Glider to the Head (10).
2. Connect the steam cleaner into the mains. Press the power on/off
button, the indicator will light blue.
3. After a few seconds half of the indicator will tum red, meaning the
appliance is ready for use.
4. Put your foot on the head and angle the body of the cleaner downwards
(6).
5. Press the trigger to release the vapour (7).
6. Move the cleaner slowly backwards and forwards paying particular
attention to frequently used areas.
MANUAL CLEANER OPERATION
1. Press the Manual Cleaner Release Button and remove the steel tube
(11).
2. Remove the Head (12).
3. Press the Water Tank Release Button and remove the Water Tank (3).
NOTE: A tube feeding water from the water tank to the boiler is loaded with
a brass ball. This design is intentional and serves to increase the efficiency
of water use. It is normal for this ball to create a rattling sound inside the
Water Tank during operation.
4. Pull the Water Tank by the cap and open it (4).
5. Fill the tank with cold tap water. Secure the tank with the cap (4). Do
not add any chemicals, detergents or perfumes to the Water Tank.
NOTE: We recommend to use distilled or de-mineralized water in order to
reduce building up mineral deposits and prolonging the life of the appliance.
CP 2000
EN
57