Cleaning The Dust Filter; Troubleshooting - Silvercrest SKHL 1800 A1 Bedienungsanleitung

RP66523 KeramikHL LB4 Seite 8 Dienstag, 24. Mai 2011 9:36 09
6.2 Cleaning the dust filter
Warning! To avoid the risk of fire:
• Clean the dust filter 10 regularly.
A clogged dust filter could cause
a build up of heat.
• Never use the fan heater without
a dust filter, otherwise dust might
gather on the heating elements
and catch fire.
Fault
Appliance cannot be Faulty fuse or wall socket
switched on
Faulty appliance
Appliance switches Safety switch has triggered
off automatically
Thermal cut-out has
triggered
Only cold air is pro- Selected temperature has
duced been reached
8
1. To remove the air inlet grille 9 , press the
locks 8 downwards.
2. Remove the dust filter 10 .
3. Clean the dust filter 10 and air inlet
grille 9 under running water.
4. Allow the dust filter 10 and air inlet grille
9 to dry thoroughly.
5. Replace the dust filter 10 and air inlet
grille 9.

7. Troubleshooting

Cause
Select another wall socket
Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
"10. Warranty" on page 9.
Set the appliance upright (see
"5.6 Safety switch" on page 7)
Allow the appliance to cool down (see
"5.5 Thermal cut-out" on page 6)
Clean the appliance (see "6. Cleaning"
on page 7)
Appliance switches on again automati-
cally as soon as the room temperature
falls
Select a higher desired temperature
Remedy