V-Check Points Lite; T_Sen1~2: Thermal Sensor Connectors; Jaud1: Front Audio Connector - MSI MEG Z490 GODLIKE Kurzanleitung

V-Check Points Lite

These voltage checkpoints are used to measure the current system voltages. A
multimeter (not included) will be required to check voltages. To measure voltage,
place test leads on the GND (screw mounting hole) and a specific V-Check Point.
Please refer to the manual of your multimeter for more information.

T_SEN1~2: Thermal Sensor Connectors

These connectors allow you to connect the thermistor cable and use it to monitor the
temperature of the detection point.

JAUD1: Front Audio Connector

This connector allows you to connect audio jacks on the front panel.
GND
VCCIO
VSA
DRAM
CPU
Sense
GND
1 MIC L
3 MIC R
5 Head Phone R
7 SENSE_SEND
9 Head Phone L
Thermistor cable
2 10
1 9
2 Ground
4 NC
6 MIC Detection
8 No Pin
10 Head Phone Detection
Overview of Components
31