W_FLOW1: Water Flow Meter Connector
This connector allows you to connect a water flow meter to monitor the flow rate of
your liquid cooling system.
T_SEN1: Thermal Sensor Connector
This connector allows you to connect the theral sensor cable and use it to monitor the
temperature of the detection point.
V-Check Points Lite
These voltage checkpoints are used to measure the current system voltages. A
multimeter (not included) will be required to check voltages. To measure voltage,
place test leads on the GND (screw mounting hole) and a specific V-Check Point.
Please refer to the manual of your multimeter for more information.
32
Overview of Components
All manuals and user guides at all-guides.com
1
2
Sense
1
Ground
3
WFLOW PWR
Thermistor cable
GND
VCCIN
VSA
GND
VCCIO
VCC_DDR
CORE
RING
WFLOW IN