Completing The Installation - Axis 216FD Installationsanleitung

AXIS 216FD Installation Guide

Completing the installation

1. Rotate the black protective shield inside the dome casing to match the camera's position.
2. Clean the dome with a dry soft cloth to remove dust and finger prints and use a blower to
remove dust from the lens.
3. Mount the dome casing using the supplied tamper-proof screws and screw driver.
4. The installation is now complete.
Accessing the AXIS 216FD from the Internet
Once installed, your AXIS 216FD is accessible on your local network (LAN). To access the
camera from the Internet, network routers must be configured to allow incoming traffic, which
is usually done on a specific port. Please refer to the documentation for your router for further
instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button and reconnect power.
3. Keep the control button pressed until the Power Indicator flashes amber (this may take up
to 15 seconds).
4. Release the control button.
5. When the Power Indicator displays green (which can take up to 1 minute) the process is
complete and the camera has been reset.
6. Re-install the AXIS 216FD using one of the methods described in this document.
More information
It is also possible to reset all parameters, except the IP parameters, to the original factory
settings via the web interface. For more information, please refer to the online help and the
user's manual. The AXIS 216FD User's Manual is available from the Axis Web site at
www.axis.com or from the Axis Network Video Product CD.
Downloaded from www.Manualslib.com manuals search engine
Page 15